Team:CIDEB-UANL Mexico/Software-Parts

From 2013hs.igem.org

Revision as of 22:48, 20 June 2013 by Dropda (Talk | contribs)

Software
Parts

This section contains information about the parts used in the robot project.

The Micro-Controller x 1:

Arduino Mega ADK, it’s an open source board with an ATmega2560 microcontroller, which will be programmed to control the machine and regulate everything in the system.

General Information:

Micro-controllerATmega2560
Operating Voltage5V
Input Voltage (recommended)7-12V
Input Voltage (limits)6-20V
Digital I/O Pins54 (of which 15 provide PWM output)
Analog Input Pins16
DC Current per I/O Pin40 mA
DC Current for 3.3V Pin50 mA
Flash Memory256 KB of which 8 KB used by bootloader
SRAM8 KB
EEPROM4 KB
Clock Speed16 MHz


More info in its development page: http://arduino.cc/en/Main/ArduinoBoardADK

Datasheet about microcontroller: http://www.atmel.com/Images/doc2549.pdf

Heat Disperser x 2:

We are using a pc, processor fan, just to keep the solution/medium at normal temperatures and to cool the resistors. In this case, we are using 2 of them.

It’s an Intel E97375-001 Socket 775 Aluminum Heat Sink Fan

Specifications:

  • Aluminum heat sink
  • 3.5-inch (90 mm) fan
  • Power input: 12VDC, 0.60A
  • Supports Socket 775 CPUs with 65W TDP


Beaker x 2:

A cylindrical container, which will contain the medium/solution. Their capacity will range from 250ml to 400ml.

Water Pump

We will be using a simple handmade water-pump, which uses the following materials:

  • Silicone Glue, as a Sealant
  • A Small Capsule, about 3cm of diameter and 4.5cm of height
  • A tiny Electrical Motor, enough to fill in the Capsule
  • Rotating Blades, little enough to fit in the motor's axis
  • Transparent Tube, About 0.5cm~1cm diameter and small thickness
cideb
cideb
Contact us! Follow us on twitter and facebook or send us a mail.
CIDEB UANL Team. Centro de Investigación y Desarrollo de Educación Bilingüe
facebooktwitterenvelope

Retrieved from "http://2013hs.igem.org/Team:CIDEB-UANL_Mexico/Software-Parts"